RV water heaters in Central Florida face two Florida-specific problems that significantly shorten their service life compared to national averages: hard water scale accumulation and propane system complications related to heat and ethanol-adjacent fuel quality issues.
Central Florida tap water hardness accelerates scale deposition on electric heating elements faster than almost any other campground region in the country. Lake County and Orange County groundwater averages 200 to 400 mg/L of calcium carbonate - water that engineers classify as hard to very hard. At these hardness levels, an electric water heater element in daily use will accumulate a visible scale coating within 6 to 12 months.
Scale is an excellent thermal insulator: a 1/8-inch scale coating on a water heater element can reduce its heating efficiency by 40 percent and causes the element surface temperature to rise well above the rated operating temperature. When an element runs hot, its protective outer sheath degrades and the element eventually fails. We find failed electric elements on Florida rigs at half the age we would expect in low-hardness water regions.
Annual element inspection and periodic acid flush of the tank is the maintenance protocol we recommend for any rig that uses campground water regularly.
Suburban and Atwood (now Dometic) gas water heaters use a pilot-and-thermocouple ignition system on older units and a DSI (direct spark ignition) module on units built after approximately 2010. The thermocouple in pilot systems is a simple thermoelectric device that is not significantly affected by Florida climate, but the DSI modules on newer units are electronic and are sensitive to the voltage spikes and dropouts common at campground pedestals.
A DSI module that is exposed to repeated brownout conditions from a loaded campground pedestal - common at Lake Louisa State Park during peak season - can develop intermittent ignition failures where the module energizes the igniter and opens the gas valve but fails to confirm ignition and shuts down. The fix is often a new DSI module, but an upstream EMS that prevents voltage fluctuations from reaching the water heater is the preventive measure.
Spider web and mud dauber wasp nest obstruction in the gas burner tube is a Florida-specific problem that we see year-round. Florida's warm climate supports year-round insect activity, and mud dauber wasps are particularly attracted to the residual warmth and shelter of an RV water heater compartment. A mud dauber nest inside the burner tube creates backpressure that causes incomplete combustion, soot deposition on the burner compartment, and eventually a blocked tube that will not sustain a flame.
This happens within weeks on a rig parked outdoors in the Orlando metro area. We recommend a fine stainless mesh screen over the burner air intake opening - a simple modification that prevents the nest buildup entirely.
The anode rod - the sacrificial magnesium rod inside every Suburban and Atwood water heater tank - depletes faster in Florida's warm water than in cold-climate installations. Warm water accelerates the electrochemical reaction that causes the anode to corrode protectively in place of the steel tank. A standard magnesium anode rod that might last 4 to 5 years in a cold-climate water heater may be fully depleted in 2 to 3 years in a rig that full-times in Central Florida.
Once the anode is gone, the tank wall begins corroding, and the first sign is rust-colored hot water. We include anode rod inspection in every water heater service call and recommend replacement on any rod that has depleted below 75 percent of its original diameter.
| Brand / Model | Common Issue in Central Florida |
|---|
| Suburban SW6DE (6-gallon gas/electric) | Electric element scale failure - the most common water heater repair in Central Florida hard water; element replacement plus a tank acid flush restores full capacity |
| Atwood G6A-2 (6-gallon gas) | Burner tube obstruction from mud dauber nests and spider webs - a Florida-specific problem requiring annual inspection of the burner compartment before spring camping season |
| Dometic WHDW6 (on-demand, gas) | Gas valve solenoid sticking in high-heat compartments - the solenoid requires a minimum voltage to open reliably, and voltage drop from a loaded shore power circuit can cause intermittent no-ignition |
| Truma AquaGo (on-demand, gas) | Flow sensor debris fouling from scale particles in hard water - the flow sensor that triggers ignition on water demand is sensitive to scale particles; an inline filter upstream prevents most fouling |
| Girard GSWH-2 (on-demand, gas) | Ignition board failures - the Girard board is sensitive to campground voltage spikes; an EMS on the shore power circuit prevents premature board failures |
| Suburban SW10DE (10-gallon gas/electric) | Anode rod depletion in 2 to 3 years under Central Florida hard water and warm water conditions - annual anode inspection is mandatory, not a 5-year interval item in this region |